RIP enables an upstream router to load balance traffic between two identical virtual servers hosted on two standalone Citrix ADC appliances. Select or clear the RIP Routing option.Navigate to System > Settings, in Modes and Features group, click Change advanced features.To enable or disable RIP routing by using the GUI: To enable or disable RIP routing by using the CLI:Īt the command prompt, enter one of the following commands to enable or disable RIP: After you disable RIP, the appliance stops the RIP process. After you enable RIP, the Citrix ADC appliance starts the RIP process. Use either of the following procedures to enable or disable RIP. You can display RIP settings to verify the configuration. For troubleshooting, you can limit RIP propagation. RIP can run on any subnet.Īfter enabling RIP, you need to configure advertisement of RIP routes. The Citrix ADC supports RIP as defined in RFC 1058 and RFC 2453. Routing Information Protocol (RIP) is a Distance Vector protocol. Traffic distribution in multiple routes based on five tuples informationīest practices for networking configurationsĬonfigure to source Citrix ADC FreeBSD data traffic from a SNIP address Using NULL Policy Based Routes to Drop Outgoing Packets Route Health Injection Based on Virtual Server SettingsĬonfiguring a Policy-Based Routes (PBR) for IPv4 TrafficĬonfiguring a Policy-Based Routes (PBR6) for IPv6 Traffic Installing Routes to the Citrix ADC Routing TableĪdvertisement of SNIP and VIP Routes to Selective AreasĬonfiguring Bidirectional Forwarding Detection Use Case 3 – Coexistence of Jumbo and Non-Jumbo flows on the Same Set of InterfacesĬitrix ADC Support for Microsoft Direct Access Deployment Keeping a VIP Address in the Backup StateĬonfiguring Link Layer Discovery ProtocolĬonfiguring Jumbo Frames Support on a Citrix ADC Appliance Monitoring the Bridge Table and Changing the Aging timeĬitrix ADC Appliances in Active-Active Mode Using VRRPĬonfiguring Health Tracking based on Interface State Setting the Timeout for Dynamic ARP EntriesĬonfiguring Multiple Untagged VLANs across Multiple SubnetsĬonfiguring Multiple VLANs with 802.1q TaggingĪssociate an IP Subnet with a Citrix ADC Interface by using VLANs Configuring Citrix ADC-owned IP addressesĬonfiguring and Managing Virtual IP (VIP) AddressesĬonfiguring ARP response Suppression for Virtual IP addresses (VIPs)Ĭonfiguring GSLB Site IP Addresses (GSLBIP)Ĭonfiguring Prefix-Based IPv6-IPv4 Translation

Routing information protocol rip